-Original-

Finite-Element Analysis of Stress on the Proximal Tibia After Unicompartmental Knee Arthroplasty

Mihoro Sano¹, Yasushi Oshima¹, Kohei Murase², Katsumi Sasatani¹ and Shinro Takai¹

¹Department of Orthopaedic Surgery, Nippon Medical School, Tokyo, Japan
²Center for Industry-University Collaboration, Graduate School of Engineering Science, Osaka University, Osaka, Japan

Background: Because the indications for unicompartmental knee arthroplasty (UKA) are limited, few patients have undergone the procedure. Therefore, it is difficult to decide the acceptable range of variation in the details of UKA on the basis of the available clinical data. The objective of this study was to identify factors that affect the distribution of stress on the proximal tibia after UKA.
Methods: Two-dimensional finite-element analysis of the proximal tibia was used to assess four factors: 1) two types of implants-all ultra-high-molecular-weight polyethylene (UHMWPE) and metal-backed implants, 2) postoperative alignment, 3) coverage of tibial bone, 4) level of the tibial osteotomy.
Results: In cases of varus alignment, high stress values and large areas of deformation were observed on and beneath the implant. In cases of valgus alignment, stress was concentrated at the lateral portion of tibial tray. In comparison with the standard model, stress concentration was greater at the medial edge of the medial condyle in a narrow-coverage model. Stress distribution for the low-osteotomy-level model did not differ markedly differ from that for the standard model. Stress distribution was better for metal-backed implants than for UHMWPE implants.
Conclusions: Proper postoperative alignment must be achieved in UKA. The osteotomy level should be set at the cancellous bone close to the joint line, and preservation of bone stock should be maximized.

J Nippon Med Sch 2020; 87: 260-267

Keywords
2-dimensional finite-element analysis (2D-FEA), unicompartmental knee arthroplasty (UKA), tibial implant, alignment

Correspondence to
Mihoro Sano, MD, Department of Orthopaedic Surgery, Nippon Medical School, 1-1-5 Sendagi, Bunkyo-ku, Tokyo 113-8603, Japan
kohoro1@gmail.com

Received, November 19, 2019
Accepted, December 25, 2019